1657: Difference between revisions

From GRWiki
Jump to navigation Jump to search
No edit summary
 
(3 intermediate revisions by 2 users not shown)
Line 7: Line 7:
|series=
|series=
|introduced=1976
|introduced=1976
|discontinued=(?)
|discontinued=1978+
|designers=Henry P. Hall
|designers=Henry P. Hall
|manuals=
|manuals=
Line 25: Line 25:
* Gipe, M.A., Hall, H.P. and Sullivan, R., "Microprocessor Simplifies Impedance Measurements", Session 1, Paper #4, Wescon 1976  
* Gipe, M.A., Hall, H.P. and Sullivan, R., "Microprocessor Simplifies Impedance Measurements", Session 1, Paper #4, Wescon 1976  
* Hall, H.P., "Analog tests: the microprocessor scores" IEEE Spectrum, April 1977
* Hall, H.P., "Analog tests: the microprocessor scores" IEEE Spectrum, April 1977
* [http://www.tauntek.com/GR1657.htm 1657 description, disassembly and Verilog simulation] @ tauntek.com


==Internals==
==Internals==
Line 39: Line 40:
1657 2.jpg
1657 2.jpg
1657 3.jpg
1657 3.jpg
GR 1657 Front.jpg
GR 1657 Front A.jpg
GR 1657 Left.jpg
GR 1657 Rear.jpg
GR 1657 Right.jpg
GR 1657 Top wo_Power Supply Cover.jpg
GR 1657 Top wo_PS and Display.jpg
GR 1657 Power Supply Top.jpg
GR 1657 Power Supply Close-Up.jpg
GR 1657 Display Board Component Side.jpg
GR 1657 Display Board Foil Side.jpg
GR 1657 Main Board Component Side.jpg
GR 1657 Main Board Diagnostic Ports.jpg
GR 1657 Main Board Foil Side.jpg
GR 1657 20uf Electrolytic Measurement.jpg
GR 1657 33 Ohm Measurement.jpg
</gallery>
</gallery>



Latest revision as of 05:06, 30 May 2024

General Radio 1657
Digital RLC meter
Genrad 1657 Digibridge

Available from 1976 to 1978+

Manuals
Catalog History
 Document Year Page
Catalog78 1978 22
(All manuals in PDF format unless noted otherwise)

The General Radio 1657 Digibridge is a digital RLC meter, introduced in 1976 1.

Specifications

please add

Links

Internals

The 1657 applies a sine wave to the measured device and a precision resistor in series. The average voltage across each is measured using four different phases relative to the input sine wave, for a total of eight measurements. From these, the resistive and reactive components of the tested device are calculated and displayed.

The 1657 uses a 6503 CPU, which is a 28-pin version of the 6502 with the same instruction set, but fewer address lines. The 1657's firmware is contained in a 2Kx8 ROM, in later versions a 2716 EPROM. A 128-byte SRAM holds scratchpad and the stack.

Photos